| |
|
Topic Title |
Replies |
Topic Starter |
Views |
Last Action |
I have version 7.0 and need to configure it to capture an A-weighted sound pressure level (SPL) for an alarm that has a sequence of 1/2 sec "Beep" followed by 1/2 sec "Quiet". What is the setup procedure to do the acquisition, post-processing and limits?
Is there an example sequence for doing this?
 |
|
|
14 |
grant |
5,451 |
11th June 2008 - 10:28 AM Last post by: Brian F |
I'm using the Voltmeter acquisition step to allow an techinician to manual move a microphone into position to obtain a particular SPL level. My limits are applied to the voltmeter in a previous step, so they show up ok now in version 6.11 on the voltmeter.
Since I use the Signal Generator to apply signal, the Signal Generator pop-ups which forces the technician to dismiss the...
 |
|
|
3 |
John Smalley |
3,353 |
22nd June 2006 - 01:38 PM Last post by: Scott |
Question: How do I configure my sequence to trigger the Acquire step?
Answer: As of SoundCheck 6.11, the only way to trigger an Acquisition in a sequence is to use the Spectrum Analyzer in the Acquisition step. When run in 'Time' format, you can configure the spectrum analyzer to run in 'Triggered' mode. This postpones any acquisition until the trigger...
 |
|
|
0 |
Scott |
2,110 |
5th June 2006 - 03:05 PM Last post by: Scott |
Question: I have a large (greater than 50ms) delay in my measurement system. Autodelay dosn't seem to work and I am losing data at the end of my measurement. How can I set up my Acquisition to account for this?
Answer: Every sound card has some internal play/record delay associated with it. For instance, when used in loopback mode, the DAL CardDeluxe has a repeatable...
 |
|
|
0 |
Scott |
2,006 |
5th June 2006 - 11:47 AM Last post by: Scott |
|
|
|