AmpConnect ISC is an all-in-one audio interface that simplifies your test setup and operation. It is a single, rugged, rack-mountable piece of hardware containing a high-accuracy audio interface, impedance box, amplifier, headphone amplifier, 2 microphone power supplies and digital I/O. It replaces multiple hardware devices, connecting to your computer via a single USB cable, and it is fully controlled by SoundCheck. This simplifies setup and calibration, eliminates cabling and reduces connectivity errors, as well as reducing overall system cost.
Used with SoundCheck software (and for some applications, a microphone, mouth simulator or ear simulator), AmpConnect ISC is the only hardware you need to realize a complete audio test system for measuring frequency response, sensitivity, distortion, impedance and more.
Although AmpConnect can function as a stand-alone hardware device, its real power is revealed when it is used with SoundCheck. Seamless plug and play integration and a simple interface that replicates the appearance of the hardware front panel make it easy to configure directly within the software. All inputs, outputs, gain, switching etc. are directly controlled using message steps within the test sequences and the front panel can be ‘locked out’ to prevent unauthorized change. This means that once a test is running, there is no need for the operator to manually adjust the hardware.
Features
• Contains soundcard, impedance box, amplifier, headphone amplifier, 2 microphone power supplies and digital IO signal router
• Single hardware box simplifies setup and minimizes errors
• Fully controlled via SoundCheck or front panel
• Rugged and rack-mountable for demanding production environments
• Excellent ground loop immunity compared to discrete components
• Easy to set up and configure
• Three-color LEDs on the front panel and software communication to SoundCheck to indicate that the microphone, device-under-test, and power amplifier levels are operating within maximum dynamic range
SoundCard
AmpConnect’s built-in 2 channel soundcard supports up to 44.1kHz sample rate. It has good dynamic range and excellent stability. Both acoustic and electrical impedance parameters can be measured simultaneously, or 2 devices measured at the same time.
Microphone Power Supplies
Dual microphone power supplies offer both BNC and XLR connectors so that balanced or unbalanced connections can be used, and a choice of bias (none, voltage or IEPE) makes them suitable for use with most microphones or ear simulators. Gain can be set from -20 to +40dB and can be set dynamically during the test via SoundCheck. A level indicator on the front panel gives a clear visual indication of clipping.
Amplifiers
The power amplifier offers a fixed 26dB of gain which is ideal for audio testing as it overcomes the problem of the gain being accidentally changed, and a power rating of 60W into 4 Ohm load provides flexibility for different speaker sensitivities . The amplifier has 2 outputs; signal may be sent to either output, both simultaneously, or back and forth when switching between 2 separate sets of fixtures. A separate headphone amplifier enables headphones to be tested, or microphone signals monitored via the headphone jack on the front panel.
Outputs
The two independently configured outputs offer an array of options. These include 2 reference loads for loudspeaker impedance measurement (Zhigh and Zlow), connecting the output of the power amp back to the soundcard for calibration, or sending reference or DUT signals to the outputs. A built-in 1V sine oscillator can route to either output for calibration or level checking. The digital I/O port provides 8 bits of digital IO that can be written and read directly in SC. This can be used for communicating with relay boards, switches, footswitches, etc. Since the outputs are independently configured, either can be selected as the active output. This increases production line productivity by permitting one test to be performed while simultaneously setting up a test on the other output.









