Automotive Audio Buzz, Squeak and Rattle Measurement
Buzz, Squeak and Rattle measurement in automotive cabin using a 6 mic array
Why make automotive audio Buzz, Squeak and rattle measurements?
The phrase “Buzz, Squeak and Rattle”, or “BSR” is widely used in the automotive industry to describe various annoying sounds caused by vibration of, or friction between parts. It is important to minimize buzz, squeak and rattle as it is perceived as a quality indicator, with cars exhibiting low BSR perceived as higher quality than those with higher levels of BSR.
While most Buzz, squeak and rattle noises occur from road vibrations, potholes, bumps etc. there is a certain subset of these noises that is caused by the car’s audio system. These are not usually identified in conventional BSR testing as these tests are carried out in a quiet environment with the infotainment system off. Infotainment system buzz squeak and rattle testing is therefore best implemented as part of the infotainment end-of-line QC checks. Such identification and repair avoids costly returns and repairs at a later stage.
There are several typical root causes of infotainment-induced Buzz Squeak and rattle, or BSR. These include manufacturing defects in the speakers, such as transient distortion caused by loose particles, and loose wires or panels that vibrate when the speaker is played at high volume.
These defects are easily identified by a combination of harmonic distortion (conventional or perceptual methods) and transient distortion measurement techniques. Sometimes these measurements are also often referred to as impulsive distortion.
Infotainment System BSR Test Configuration
Buzz, Squeak and Rattle Testing is easily implemented using SoundCheck. The AmpConnect 621 6-input test interface is designed to receive 6 microphone inputs from the 6 mic array and provides a convenient one-box interface that along with the SoundCheck software, handles the entire test. All that is needed in addition is a 6-microphone array and some method of interfacing with the car so that the test signal can be played through the infotainment system. A Bluetooth interface is often the simplest setup, although other options include A2B bus and SSD drive.

Test configuration for automotive audio Buzz, Squeak and Rattle Measurement
Video Demonstrations of Automotive Buzz, Squeak and Rattle Measurement
This 30 minute video demonstrates BSR tests (along with Max SPL and frequency response measurements) in a Tesla using SoundCheck, the AmpConnect 621 audio interface and the BTC Bluetooth interface.
Additional Resources for Buzz, Squeak and Rattle Measurement
Infotainment system BSR measurements are well documented in the Audio Engineering Society Technical Committee on Automotive Audio (TC-AA) in-vehicle measurements white paper (draft). This white paper aims to define repeatable and defined car audio system measurements and in addition to the measurement methods, contains information on standardized test configuration, for example microphone and seat positioning.
The SoundCheck test sequences used in this video are available for free download: Get Buzz, Squeak & Rattle test sequence.


