Organizing SoundCheck Data with the Memory List
Additional Resources for SoundCheck
Detailed explanations of how to use SoundCheck can be found in the SoundCheck manual.
Video Transcript: Organizing SoundCheck Data with the Memory List
By default, when you run a sequence in SoundCheck, previously acquired sequence data in the memory list is overwritten and will be lost unless you configure the sequence to autosave your data.
Today, I’ll demonstrate how to use memory list functions to safeguard your sequence data, ensuring it remains in the memory list until you choose to manually save it, delete it, or close your SoundCheck session.
After running a sequence, I want to preserve the fundamental curve so it’s not overwritten during the next sequence run. To do this, I highlight the fundamental curve, right-click, go down to “Protect Data” in the drop-down menu, and select “Protect.” The protected version of the fundamental curve now appears down here. This checkmark shows it’s no longer sequence data, and the dash “P” indicates it is protected. Now we can remove this piece of protected data from the memory list, and I’ll show you how to autoprotect data.
In this case, I want to autoprotect the fundamental and the THD curve so that every time I run the sequence, it’s automatically protected. Once again, I’m going to hover over the “Protect Data” menu and select “Autoprotect.” The fundamental and THD icons change from rounded shapes to diamonds to indicate the data is autoprotected. Now, every time I run the sequence, the fundamental curve and the THD curve are Autoprotected and remain in the memory list. I’ve run the sequence four times, and you can see four autoprotect instances of the fundamental and THD curves.
Now, if we get rid of these autoprotected curves, and highlight the fundamental and THD curves, I can undo the autoprotection. As you can see, they revert to their traditional circle icons, and upon re-running the sequence again, all of our data will populate.
Lastly, I’ll demonstrate how to protect data by renaming it, including renaming multiple curves simultaneously. I’m going to select fundamental, THD, and then choose the “Rename” option. This prompts the rename dialogue, where I can designate them as “Fundamental 1-2-3”, and “THD 1-2-3. Upon renaming these curves, they also appear in the memory list as protected items.
So that’s 3 methods we can use to retain data in the memory list – Autoprotect, Protect, and Rename. Try it out, and give us a shout if you have any questions.




