Waveform 1 shows the raw recorded acoustic waveform.
Hear it:
Waveform 2 shows the extracted artifacts (Loose Particle waveform). This Loose Particle waveform can be played through SoundCheck on a reference loudspeaker or headphone to listen to the recorded artifacts and enable audible correlation to the measured results.
Hear it:
Waveform 3 shows the envelope analysis, a time domain measurement of the energy in the recorded waveform, plotted against time. Transient defects are revealed as an anomalous burst of energy.
Waveform 4 shows the calculated Prominence of each peak. The Prominence Threshold, the level above which an event will be counted, is indicated by the horizontal red line, and events above the threshold are highlighted in red. These highlighted events are counted over the duration of the measurement to determine the loose particle count.
Performance
Here we compare the results obtained with this algorithm for a good speaker and one with known ‘Loose Particle’ transient distortion defects.
Good Speaker
Here we show both the response waveform and the enhanced Loose Particle metric (transient distortion) for a good speaker with no known defects.
Response Waveform
eLP Artifacts
Bad Speaker
These graphs show the same data for a speaker with a significant transient defect. The defect is clearly visible on the response waveform, and the correlation between the magnitude of the distortion and the magnitude of the eLP prominence (red spikes) is clear.
Response Waveform
eLP Artifacts












