USB Headset Input/Output Test Sequence
The purpose of these sequences is to test the left and right earphone outputs as well as the microphone input of a USB headset. Because SoundCheck supports both analog and digital interfaces, the headset simply plugs into a computer USB port and configures as a digital channel to be
tested like a conventional device. For output testing, a 1 kHz pilot tone alongside a 20 kHz to 100 Hz Stweep stimulus is played through the headset and captured by HATS ear simulators. For input testing, an 8 kHz to 100 Hz stimulus with a 1 kHz pilot tone is played through the HATS mouth simulator and recorded by the headset microphone. While the pilot tone is excluded from analysis, SoundCheck uses it during a frequency shift step to align the time and phase of the response signal to the stimulus. SoundCheck then analyzes the frequency response by comparing the original stimulus to the captured recording, using post-processing to calculate average sensitivity for the microphone as well as THD and L/R balance for the outputs, with all final results plotted on display.




