USB Headset Input/Output Test Sequence
The purpose of these sequences is to test the left and right earphone outputs as well as the microphone input of a USB headset. Because SoundCheck supports both analog and digital interfaces, the headset simply plugs into a computer USB port and configures as a digital channel to be
tested like a conventional device. For output testing, a 1 kHz pilot tone alongside a 20 kHz to 100 Hz Stweep stimulus is played through the headset and captured by HATS ear simulators. For input testing, an 8 kHz to 100 Hz stimulus with a 1 kHz pilot tone is played through the HATS mouth simulator and recorded by the headset microphone. While the pilot tone is excluded from analysis, SoundCheck uses it during a frequency shift step to align the time and phase of the response signal to the stimulus. SoundCheck then analyzes the frequency response by comparing the original stimulus to the captured recording, using post-processing to calculate average sensitivity for the microphone as well as THD and L/R balance for the outputs, with all final results plotted on display.


followed by a period of silence, which is recorded through the device under test. The silence interval is analyzed using a constant 30 Hz, 4096-sample Flat Top FFT to derive the tonal noise spectrum. A dynamic tolerance mask is then generated by applying 1/1 octave smoothing to the noise curve and adding a +10 dB offset across the entire frequency range. If the unsmoothed noise spectrum peak stays below this tolerance mask, the device passes the test.
through the device under test to detect potential narrow-band impairments caused by internal electrical, fan, or drive noise. The recorded waveform is analyzed using a constant 30 Hz, 4096-sample Flat Top FFT to derive the tonal noise spectrum. A dynamic tolerance mask is then generated by applying 1/1 octave smoothing to the noise curve and adding a +10 dB offset across its entire frequency range. If the unsmoothed tonal noise spectrum peak stays below this tolerance mask, the device passes the test.


TIA 920-B is a comprehensive US dual-bandwidth standard that applies to both narrowband (NB) and wideband (WB) devices. It also allows a choice between Free Field (FF) and Diffuse Field (DF) as the Listener Reference Point (LRP). These sequences measure digital communications devices with handset features according to TIA-920.110-B, speakerphones according to TIA-920.120-B, and headsets according to TIA-920.130-B. 