SoundCheck’s FFT Analyzer and RTA: Live or in a Sequence
Understand when to use SoundCheck’s FFT Analyzer and RTA live versus in a sequence. In this video, we’ll show how live multi-instrument FFT/RTA measurements are ideal for real-time adjustments and troubleshooting, while sequence-based analysis steps enable automated, repeatable measurements, averaging over time, and advanced calculations like frequency response.
Additional Resources for SoundCheck
Detailed explanations of how to use SoundCheck can be found in the SoundCheck manual.
Video Transcript: SoundCheck’s FFT Analyzer and RTA: Live or in a Sequence
In SoundCheck, you can run an FFT or an RTA either live via the multi-instrument or through the analysis step in a sequence.
Let’s outline the differences.
Taking an FFT or an RTA via the multi-instrument is always an input-only measurement and it displays the live curves and changes over here in the graph. So, as I’m talking, you’ll see that these are displaying the current measurement on my reference microphone. This is very helpful for live adjustments – for example if I’m changing the DSP on a device and I want to see how it behaves, or checking the seal on some headphones. When you’re looking at it live, you can change settings on the fly, so using these controls I can see what happens if I switch from average to max hold, min, or change the windowing or weighting directly in the instrument. Most of this can be done in the analysis step as well, but you might have to rerun the acquisition or open an editor and click apply before you’re able to see the results, whereas here you can see the changes instantly.
The instrument is also very helpful for troubleshooting. If something is wrong with a measurement,you can just open up an FFT or an RTA to troubleshoot what’s happening and then solve it.
If we instead look at the FFT and RTA in a sequence, I can use an acquisition step set to record only. I can then run that reference microphone recording through an FFT spectrum analysis step and an RTA spectrum analysis step to get the FFT and RTA spectrum response for my reference mic. Instead of seeing live changes, I can define the full time length I’m recording and then average across that full recording. This is useful if you want to test something over a set number of seconds and just see the total average there without any additional user interaction. It’s much easier to automate.
There are some calculations we can do in the live multi-instrument. For example, I can look at the power average of multiple inputs and do some basic operations like subtraction and addition. One of the options we have here that’s exclusive to the live multi-instrument is a masking curve. I can play a signal here, add a masking curve, and I can then quickly see what parts of my spectrum are being masked by a dominant tone. That’s only available in the live multi-instrument.
Virtual instruments can be added to sequences in an acquisition step. When used this way, both the instrument and analysis steps output the curves to the memory list of the sequence once the step is complete. Post processing, limits, or statistics can be used for further calculations on the measurements.
There are two common use cases where an analysis step would be required rather than using the virtual instrument: Using previously recorded waveforms and measuring a frequency response.
For example, if I have wave file recordings from a past measurement, or an open-loop test, I can recall those and add them directly into an analysis step.
We also use an RTA analysis step to measure the frequency response of a device under test. The virtual instrument only calculates an RTA Spectrum of the input signal path, but the analysis is able to calculate spectra for both the Stimulus and Analysis waveforms. This then allows a frequency response calculation. The FFT analysis step will only measure a spectrum for the response waveform, but using the Transfer Function analysis step you can perform complex FFT on the stimulus and response waveform to output a frequency response.




