日志 Zarina

Evolution of Time-Frequency Analysis Methods and their Practical Applications

Time-Frequency analysis has been in use for more than 20 years and many different Time-Frequency distributions have been developed. Four in particular, Short Time Fourier Transform, Cumulative Spectral Decay, Wavelet and Wigner-Ville have gained popularity and firmly established themselves as useful measurement tools. This paper compares these four popular transforms, explains their trade-offs and discusses […]

Challenges of MP3 Player Testing

MP3 player audio performance is discussed including measurements of frequency response, phase response, crosstalk, distortion, sampling rate errors, jitter, and maximum sound pressure level with headphones. In order to make these measurements, several measurement techniques and algorithms are presented to overcome some of the challenges of testing MP3 players. We discuss test equipment requirements, selection […]

The Challenges of MP3 Player Testing

Author: Steve Temme MP3 players have been the ‘must-have’ electronic gadget for the past few years. Over 10 million players were sold in 2005, and this is predicted to rise to more than double this by 2010. But how can manufacturers carry out QA tests on the production line, ensure excellent sound quality and demonstrate […]

A New Method for Measuring Distortion using a Multitone Stimulus and Non-Coherence

A new approach for measuring distortion based on dual-channel analysis of non-coherence between a stimulus and response is presented. This method is easy to implement, provides a continuous distortion curve against frequency, and can be used with a multitone stimulus, noise, or even music. Multitone is a desirable test signal for fast frequency response measurements […]

Higher Order Harmonic Signature Analysis for Loudspeaker Defect Detection

Loudspeaker assembly faults, such as a rubbing voice coil, bent frame, loose spider, etc., have traditionally been detected using experienced human listeners at the end of a production line. Previous attempts to develop production measurement systems for on-line testing typically analyze only low-order harmonics for the primary purpose of measuring total harmonic distortion (THD), and […]

Enhancements for Loose Particle Detection

During loudspeaker production, particles may become trapped in the loudspeaker motor and voice coil vicinity, resulting in a distinctive defect that is easily heard, but difficult to detect by traditional test and measurements. We found that a Sine Sweep Stimulus followed by a High Pass Filter and RMS Envelope Analysis efficiently detected Loose Particles and […]

Soundcard-Based Production Line Loudspeaker Test

Author: Steve Temme Reprinted from the July 2004 issue of Voice Coil Steve Temme discusses high-end loudspeaker manufacturer, Peerless’s choice of SoundCheck® as their standard for testing their loudspeakers. Full Article   Article Introduction Soundcard-Based Production Line Loudspeaker Test By Steve Temme, Listen Inc. Quality and reliability are critical factors for success in the audio […]

Loose Particle Detection

During the loudspeaker manufacturing process, particles may become trapped inside the loudspeaker, resulting in a distinctive defect that is easily heard but difficult to measure. To give a clearer view of the problem, Time-Frequency maps are shown for some defective loudspeakers. Based on this analysis, a reliable testing procedure using a swept-sine stimulus, high-pass filter, […]

Simultaneous measurement of impulse response and distortion with a swept-sine technique

This landmark paper by Angelo Farina discusses the benefits of the Log Sine Sweep (also known as Frequency Log Sweep or Log Chirp), one of the test signals available in SoundCheck. A novel measurement technique of the transfer function of weakly not-linear, approximately time-invariant systems is presented. The method is implemented with low-cost instrumentation; it […]

Virtual Instruments for Audio Testing

Although Virtual Instruments have been part of SoundCheck as long as most of us can remember, back in 1998 this was a huge innovation. This paper introduces the concept at a time when computerized audio measurement was a novel concept. Authors: Steve Temme Presented at the 105th AES Convention, San Francisco, 1998 Full Paper