How to Measure Free Field Speaker Response without an Anechoic Chamber
Did you know
you can make free field speaker response measurements without an anechoic chamber? In the March 2021 issue of VoiceCoil, Steve Temme explains his unique method for achieving this. The article explains how the ‘splice’ method results in a full range frequency response from a combination of near-field and windowed far-field measurement, and compares the results with anechoic chamber measurements and the manufacturer’s published response curve.
Simulated Free Field Speaker Response Measurement
Source: “How to Measure Free-Field Speaker Response without an Anechoic Chamber” by Steve Temme, Voice Coil, March 2021.
Main Theme: The article presents a practical and cost-effective method to obtain simulated free-field speaker response measurements without needing an anechoic chamber, particularly useful for those working with limited resources.
Key Ideas/Facts:
- Challenge: The COVID-19 pandemic highlighted the difficulty of conducting free-field speaker measurements outside a lab setting, as anechoic chambers are not easily transportable.
- Traditional Solutions (and their limitations):
- Anechoic Chambers: Expensive and not readily accessible. Suffer from low-frequency cut-off limitations depending on chamber size.
- Large Open Spaces: Impractical due to logistical challenges and uncontrollable environmental factors.
- Proposed Solution: The article advocates for the “splice measurement” technique, a long-established but often overlooked method.
- How it Works: Combines a near-field measurement (accurate at lower frequencies) with a time-windowed far-field measurement (captures higher frequencies).
- Software Simplification: SoundCheck software (specifically version 18 or newer with the LogTSR module) greatly simplifies the process with a dedicated test sequence.
- Practical Implementation:
- Requires: SoundCheck software, audio interface, microphone, amplifier (optional), and a standard room.
- Procedure: The software guides the user through near-field and far-field measurements, suggests a time-window for the far-field data, and then automatically splices the measurements together.
- Case Study: Indy Acoustic Research successfully used this method to measure a Tannoy System 600 speaker, achieving results comparable to measurements taken in an anechoic chamber.
- “These results demonstrate how simulated free-field measurement using a splice sequence to combine near-field measurements and time-windowed far-field measurements yield results that align well with those made in an anechoic chamber.”
- Advantages:
- Cost-effective alternative to anechoic chambers.
- Achievable in a typical room setting.
- Relatively simple setup and execution using readily available software.
Significance: This technique provides a valuable tool for audio engineers and acoustic professionals to obtain accurate free-field speaker measurements without significant investment or reliance on specialized facilities. This is particularly beneficial for smaller companies, independent researchers, or anyone needing to conduct these measurements remotely.




