Author: Steve Temme Reprinted from the July 2004 issue of Voice Coil Peerless chooses SoundCheck® as their standard for testing their loudspeakers.
This author has yet to write their bio.Meanwhile lets just say that we are proud Zarina contributed a whooping 336 entries.
Entries by Zarina
During the loudspeaker manufacturing process, particles may become trapped inside the loudspeaker, resulting in a distinctive defect that is easily heard but difficult to measure. To give a clearer view of the problem, Time-Frequency maps are shown for some defective loudspeakers. Based on this analysis, a reliable testing procedure using a swept-sine stimulus, high-pass filter, […]
This landmark paper by Angelo Farina discusses the benefits of the Log Sine Sweep (also known as Frequency Log Sweep or Log Chirp), one of the test signals available in SoundCheck. A novel measurement technique of the transfer function of weakly not-linear, approximately time-invariant systems is presented. The method is implemented with low-cost instrumentation; it […]
Although Virtual Instruments have been part of SoundCheck as long as most of us can remember, back in 1998 this was a huge innovation. This paper introduces the concept at a time when computerized audio measurement was a novel concept. Authors: Steve Temme Presented at the 105th AES Convention, San Francisco, 1998 Full Paper
Author: Steve Temme The sine generator in SoundCheck®, operates on the same principles as a traditional swept sine measurement system consisting of a sine generator, voltmeter, tracking filter, and level recorder. The main difference is that it is implemented in the software as a virtual instrument. The SoundCheck sine generator sweeps in discrete steps; each […]
Author: Steve Temme Loudspeaker distortion is undesirable. The type and level of distortion, however, can greatly influence the perceived annoyance. In addition, identifying the type of distortion can also help pinpoint the mechanism or mechanisms in the loudspeaker that are causing the distortion. “Rub & Buzz” is a good example of a particularly annoying type […]
We have no training webinars currently scheduled. We will be announcing our 2016 series in the new year, so please check back soon.
Authors: Steve Temme and Christopher J Struck Evaluation of loudspeaker performance at low frequencies is complicated by long wavelengths, room interaction and cabinet/baffle diffraction. Since low frequency measurements have traditionally required large, impractical testing environments, different techniques have been developed in an attempt to overcome this requirement. Anechoic chambers, outdoor measurements, half-space measurements, ground plane […]
Author: Steve Temme In the never ending quest for better sound transmission, reinforcement, and reproduction, the electronics have been extensively analyzed for distortion. Distortion in the electroacoustic transducers, while typically several orders of magnitude greater, has often been neglected or not even specified because it has been difficult to measure and interpret. With a basic […]
Author: Martin Rung A time selective measurement of a frequency response is (directly or indirectly) based on a measurement of the impulse response, where a well-defined time window is applied to the impulse response. The frequency response is simply the Fourier transform of the impulse response. Time selective measurements are often used in electroacoustics to […]
- AES Convention– New York – October 16-19, 2019October 16, 2019 - 5:51 pm
- New Sales Director: Joe KushiAugust 12, 2019 - 2:51 pm
- AES International Conference on Headphone Technology – San Francisco – August 27-29, 2019August 12, 2019 - 2:15 pm
- AES International Conference on Automotive Audio – Munich – September 11-13, 2019August 12, 2019 - 1:55 pm
- ISEAT- Shenzhen, China – Nov 9-10, 2019August 12, 2019 - 10:10 am